ESP32-S3-DevKitC-1U-N8R8, ESP32-S3-WROOM-1-N8R8, 8MB Quad Flash and 8 MB Octal PSRAM

Description:

Flash and PSRAM: Flash：8 MB QD, PSRAM：8MB OT.
RGB LED: Driven by GPIO8, Addressable RGB LED
LDO: 5V-to-3.3V Low dropout voltage regulator (LDO)
5V Power On LED: When the board is powered up, the LED will light up.
USB-UART bridge: Single USB-UART bridge chip provides transfer rates is 3 Mbps.
Module:
ESP32-S3-DevKitC-1 is an entry-level development board with ESP32-S3-WROOM-1, a general-purpose Wi-Fi +BT LE MCU module with full Wi-Fi
and Bluetooth LE functionality .It provides acceleration for neural network computation and signal processing workloads. And comes with PCB antenna.
About Button:
ESP32-S3-DevKitC-1 N8R8 has a restart button and a download button, the restart button is used to restart the system. Press and hold
Boot and then press Reset to initiate firmware download mode, which can be used to download firmware through the serial port.
ESP32-S3 USB Port:
ESP32-S3 full-speed USB OTG interface compliant with USB 1.1 specification. This interface is used to power the board, flash applications
to the chip, communicate with the chip using the USB 1.1 protocol, and JTAG debugging.
Pin headers:
For ease of interfacing and programming, most of the I/O pins are routed to headers on both sides of the board. You can choose to use jumper
wires to connect peripherals or use the ESP32-C3-DevKitC-02 mounted on a breadboard.

Hardware you need to have
1.ESP32-S3-DevKitC-1
2.USB 2.0 cable (Standard A to Micro-B)
3.Computer running Windows, Linux, or macOS

Your choice of power supply
1.USB-to-UART Port and ESP32-S3 USB Port (either one or both), default power supply (recommended)
2.5V and GND pin headers
3.3V3 and GND pin headers

Package Included:
1 X ESP32-S3-DevKitC-1 N8R8 Development Board